This is my daily rig that i primarily use for gaming with the occasional stream, Photoshop work . I have changed many parts of the past, last piece i changed over was the titan x and was the best decision ever. I had to patch the motherboard to gen 3 for the card but after that was done I've had nothing but fps ownage during gaming. I normally play with v-sync enabled because most games it just puts unnecessary strain on the card lol
Fluid used inside the loop is Fluid XP's EXT performance liquid. Ive only had to drain the loop once after my first mcp35x burned out. This stuff keeps my cpu cooled to a 68 degrees when using Aida 64 full stress. I'm sitting at 4.6ghz on all cores with a voltage of 1.34. I keep the 1 Typhoons at 1850rpm at the top blowing in through the rad with demciflex filter on top. I only dust the case out every few months and it hardly has anything in it. I have it set for high positive pressure.
My Titan X is overkill yes but inside this case it works..I have a fan angled down blowing directly down on top of it, along with the backplate it keeps it cool and i have never seen it go over 68 degrees. The evercool front bay is supplying the cold air to this said fan. I do have a custom fan profile set for this. I am thinking of buying the hybrid kit and making it AIO cooled , use the exhaust as the rad spot but right now im happy with its performance.
I use the bottom chamber for the pump and used the rubber grommets for the tubes to keep it hidden. The pump normally runs hot but because its just above the vent/dust filter at the bottom and just below a 140mm intake the pressure and air flowing over it keeps it cool.
Next change will most likely be a new reservoir and possibly change over the rad/fan position to push using the same 120mm version of the exhaust fan. (Thermaltake ring - red).