Yes, a couple of small modification included covering up all cable passthrough holes with white acrylic, so that I could only have cable sized holes for the cables as well as drilling 4 holes in total for the water cooling pass through.

Hi, this build only uses exhaust fans without any heat issues, so far I'm only running an overclocked CPU and neither the CPU nor the GPU exceed 48 degrees celsius under full load. If temperature becomes a problem in the future I have 2x 140 (cryorig XT140) super slim fans that can be mounted on the bottom of the case and push air inside, as the bottom of the case is perforated with a lot of air holes and the case sit's about 1-1.5 inch above the table. If this would be a single loop I'd have used intake fans, but as they're two separate loops it seems to be doing very fine.

they are Black Ice Nemesis 360GTS Ultra Stealth U-Flow Low Profile Radiators to combat the limited space, as otherwise I'd have had even more space issues with the tubing and the through put holes on the top side, as well as space issues with the reservoirs and the GPU. I already had to modify the GPU to fit with the current setup.

I will try to add some images from the rear in the next few days.

Idle: CPU - 30 (with OC to 4.4 Ghz) GPU - 26

Load: CPU - 48 - 56 (gaming for several hours to running concurrent virtual machines and high amount of computations) GPU - 42 -44

yeah saw it this morning, super stoked :)

Hi thank you! the LED strip is from Dazmode - Dimmable Rigid LED Strip V2 but any led strip would work for this to be honest. The white plate is just an acrylic plate with low opacity.